Tools
- Battery cover
- Cut-resistant gloves
- Nylon probe (black stick)
- Pentalobe screwdriver
- Torque driver (blue, 0.65 kgf cm)
- Torx Plus 3IP 44 mm half-moon bit
- Adjustable torque driver (10–34 Ncm)
- Torx Plus 5IP 50 mm bit
Also check the tools for every linked access procedure. Match Torx and Torx Plus bits to the screw specified.
Parts and supplies
A new exact-model battery assembly. This procedure uses a screw-fastened tray; preserve the alignment set screws.
Compare the exact model and part number before installation. Confirm all required screws, adhesive, tape, foam and fixtures in the complete procedure.
Exact-model documentationBefore you begin
Choose Apple menu → About This Mac and confirm the model, chip and screen size. For Intel 2020 MacBook Pro, also match the two-port or four-port version. A similar enclosure does not establish parts compatibility.
Battery and workspace precautions
Follow the discharge instruction in stage 1 before opening. A swollen, punctured, dented or unusually hot battery needs specialist handling. Do not bend, heat or force it. Protect your eyes, prevent accidental startup and disconnect power before adjusting any internal connection.
Repair sequence
Work through these stages with the complete illustrated procedure open. It contains the detailed screw map, torque values, connector directions and reassembly order for this model.
Open the complete illustrated procedureConfirm the part and prepare
Discharge the battery fully, following the exact-model safety procedure, before opening. Back up your files, shut down, unplug all cables and work on a clean, ESD-safe surface.
Open the bottom and isolate power
Keep the lid closed while removing the bottom-cover screws and releasing its clips. Disconnect the battery power and data connections in the illustrated order before touching internal cables. Map every screw to its location.
Bottom cover removal reference 1Apple diagram 1 of 2 Complete the access steps
With power isolated, remove the connector covers shown in the photos. Keep their screws and any reusable insulating material organized.
Free the battery tray
Disconnect and move the speaker and audio-board flexes clear. Protect the battery, then remove its 18 5IP fasteners. Leave the alignment set screws in place. Slide and lift the tray clear.
Battery removal reference 1Apple diagram 1 of 5 Fit and secure the new battery
Align the tray on its set screws, keeping cables clear. Refit the 18 screws at 17.5 Ncm in the illustrated order. Reconnect and route the audio-board and speaker flexes.
Battery reassembly reference 1Apple diagram 1 of 3 Reassemble and complete the repair
Restore all removed parts, covers and cable routes in the full procedure’s reassembly order. Reconnect battery power only at the specified stage, inspect for loose hardware, close the bottom and complete the checks below.
Illustrated repair resources
Final checks
Use these checks after reassembly. Checkboxes reset when you leave the guide.
Prefer a professional repair?
Get help with diagnosis, parts compatibility or installation.
UWS organizes these repair stages and checks with credited repair resources. Follow the complete procedure for your exact hardware and replacement part. Available functions depend on part compatibility and any required calibration.