Tools
- Battery cover
- Microterry polishing cloth
- Nylon probe (black stick)
- Pentalobe screwdriver
- Permanent marker
- Suction cup
- Torx T8 screwdriver
Also check the tools for every linked access procedure. Match Torx and Torx Plus bits to the screw specified.
Parts and supplies
A complete display/lid assembly with frame, matched to the exact model, chip, size and finish. Confirm the included camera, cables and hinges.
Compare the exact model and part number before installation. Confirm all required screws, adhesive, tape, foam and fixtures in the complete procedure.
Exact-model documentationBefore you begin
Choose Apple menu → About This Mac and confirm the model, chip and screen size. For Intel 2020 MacBook Pro, also match the two-port or four-port version. A similar enclosure does not establish parts compatibility.
Battery and workspace precautions
Follow the discharge instruction in stage 1 before opening. A swollen, punctured, dented or unusually hot battery needs specialist handling. Do not bend, heat or force it. Protect your eyes, prevent accidental startup and disconnect power before adjusting any internal connection.
Repair sequence
Work through these stages with the complete illustrated procedure open. It contains the detailed screw map, torque values, connector directions and reassembly order for this model.
Open the complete illustrated procedureConfirm the part and prepare
Discharge the battery fully, following the exact-model safety procedure, before opening. Back up your files, shut down, unplug all cables and work on a clean, ESD-safe surface.
Open the bottom and isolate power
Keep the lid closed while removing the bottom-cover screws and releasing its clips. Disconnect the battery power and data connections in the illustrated order before touching internal cables. Map every screw to its location.
Bottom cover removal reference 1Apple diagram 1 of 2 Complete the access steps
Complete these linked procedures in order: Logic board; Antenna module. Preserve cable routing and keep the battery protected during each step.
Remove the full display
Support the lid at 90°. Remove the six T8 hinge screws. Tilt and lift the hinges clear, keeping the display’s TCON board protected.
Display removal reference 1Apple diagram 1 of 3 Align and secure the replacement
Position the display and TCON board correctly inside the case. Start all hinge screws loosely, align the closed lid flush, then secure them in the illustrated order.
Display reassembly reference 1Apple diagram 1 of 3 Reassemble and complete the repair
Restore all removed parts, covers and cable routes in the full procedure’s reassembly order. Reconnect battery power only at the specified stage, inspect for loose hardware, close the bottom and complete the checks below. Run the supported Repair Assistant or calibration process described in the manual.
Illustrated repair resources
MacBook Air (M1, 2020) Display
Apple
Final checks
Use these checks after reassembly. Checkboxes reset when you leave the guide.
Prefer a professional repair?
Get help with diagnosis, parts compatibility or installation.
UWS organizes these repair stages and checks with credited repair resources. Follow the complete procedure for your exact hardware and replacement part. Available functions depend on part compatibility and any required calibration.