Tools
- Clampy - Anti-Clamp
- Suction Handle
- Opening Picks (Set of 6)
- Battery Blocker
- iOpener
- Tweezers
- Phillips #00 Screwdriver
- Spudger
- Adhesive remover specified in the procedure
- Halberd Spudger
- Isopropyl Alcohol
- Packing Tape
- Safety Glasses
- Deck of Cards
- Coffee Filters or a lint-free cloth
Parts and supplies
Confirm the replacement part and the source's complete supply list for your exact model and Wi-Fi or cellular variant before starting.
Display adhesive is normally replaced after opening. Follow the source's requirements for screws, tape, foam and calibration.
Before you begin
Confirm the model in Settings → General → About and match the screen size and Wi-Fi or cellular version. A similar-looking iPad can have different cables, screws and replacement parts.
Identify your iPad with AppleBattery and glass precautions
Back up your data and disconnect all accessories. Follow the selected source's discharge and power-isolation instructions before opening. A swollen, dented, punctured or unusually hot battery needs specialist handling; do not heat, bend or pry it. Protect your eyes from broken glass. Power down before adjusting an internal connection.
Repair sequence
The selected procedure below contains the detailed illustrated steps, including removal, reassembly notes and model-variant differences. Choose the matching Wi-Fi/cellular version and component before starting.
Match the procedure and part
iPad Air (3rd generation) uses Lightning. Confirm the exact generation, screen size and connectivity variant. Compare the replacement assembly with the source’s parts list.
Prepare and open
Back up the iPad, unplug it, power it off and follow the source’s battery-discharge requirement. Read the entire illustrated procedure before cutting adhesive. Keep cables supported and all screws organized.
Create an opening gapRepair photo 1 of 2 · iPad Air 3Robert Boyd and contributors · View source step ↗The source may reuse photographs from a related variant. Follow its model-specific notes and compare cable routing before lifting parts. Complete the illustrated replacement
Follow the selected display procedure in order. Observe every isolation, adhesive and connector caution in the source. Stop when the hardware or cable layout does not match the selected variant.
Display flex connectionsRepair photo 1 of 3 · iPad Air 3Robert Boyd and contributors · View source step ↗The source may reuse photographs from a related variant. Follow its model-specific notes and compare cable routing before lifting parts. Reassemble
Follow the source’s reverse-order instructions and special reassembly notes. Fit fresh specified adhesive, restore all shields/grounds and inspect for loose screws and trapped cables. Do not force a display that will not sit flush.
Verify the repair
Complete the checklist below. If a function fails, power down before inspecting a connection. Do not continue charging a device that becomes abnormally hot.
Illustrated repair resources
iPad Air 3 Screen Replacement
Robert Boyd and contributors · 23 illustrated steps
The source may reuse photographs from a related variant. Follow its model-specific notes and compare cable routing before lifting parts.
Open the complete illustrated procedureOpen the complete procedure for every detailed step, model-specific precaution and reassembly note.
Final checks
Use this checklist after reassembly. These checkboxes are a working aid and reset when you leave the guide.
Prefer a professional repair?
Get help with diagnosis, parts compatibility or installation.
UWS organizes these repair steps and checks with credited third-party repair resources. Source demonstrations are not a UWS technician sign-off. Follow the full source procedure for the exact variant. No repair restores a guaranteed factory seal, and replacement-part functions depend on the part and any required calibration.